| Author |
Washing Machine imbalance
|
|
| A Veteran for Peace 2005-11-10, 2:21 pm |
| On the spin cycle a horrible "thumping"
It's a Whirlpool. re-arranging the clothes about doesn't help.
--
Impeach Bush ! a noble cause
Operation Iraqi Liberation = O.I.L.
| |
|
|
|
| Level the front of the machine, then lift the rear slightly and let it
down. Tom
| |
| Patrick Cleburne 2005-11-10, 4:21 pm |
| "A Veteran for Peace" <georgek@humboldt1.com> wrote in message
news:georgek-AE4FE5.09420610112005@corp.supernews.com...
> On the spin cycle a horrible "thumping"
> It's a Whirlpool. re-arranging the clothes about doesn't help.
>
> --
> Impeach Bush ! a noble cause
> Operation Iraqi Liberation = O.I.L.
I can tell you how to fix that-- but after reading your sig, I decided that
you can just listen to it.
Patrick
| |
|
| Maybe your over loading the machine?
Tom
"A Veteran for Peace" <georgek@humboldt1.com> wrote in message
news:georgek-AE4FE5.09420610112005@corp.supernews.com...
> On the spin cycle a horrible "thumping"
> It's a Whirlpool. re-arranging the clothes about doesn't help.
>
> --
> Impeach Bush ! a noble cause
> Operation Iraqi Liberation = O.I.L.
| |
|
| Most of the time it's a floor problem. Make sure the front legs are screwed
all the way up and locked. If there is a dryer next to the washer you may
notice that it shakes too. If it does it is most likely a 'soft' floor.
"A Veteran for Peace" <georgek@humboldt1.com> wrote in message
news:georgek-AE4FE5.09420610112005@corp.supernews.com...
> On the spin cycle a horrible "thumping"
> It's a Whirlpool. re-arranging the clothes about doesn't help.
>
> --
> Impeach Bush ! a noble cause
> Operation Iraqi Liberation = O.I.L.
| |
| Gary Dyrkacz 2005-11-10, 9:21 pm |
| On Thu, 10 Nov 2005 09:42:07 -0800, A Veteran for Peace
<georgek@humboldt1.com> wrote:
>On the spin cycle a horrible "thumping"
>It's a Whirlpool. re-arranging the clothes about doesn't help.
On our Sears Kenmore I found another possibility which has some of the
same characteristics as either a load imbalance or leveling problem.
After taking the back off to investigate I noticed that there was a
large spring laying on the floor beneath the washer motor. After
staring at the innards for a long time I figured out that the spring
was attached to the bottom edge of the back frame and to the drive
unit. The hole in the frame had broken out and released the spring.
Apparently, this spring must help keep tension on the drum and drive
system to maintain the balance. Might have to do with torgue..I don't
know??? At any rate, my solution was to drill another hole in the
frame near the original hole and reinstall the spring. That fixed the
problem. This was about a year ago.
Gary Dyrkacz
REMOVETHISBEFORESENDINGdyrgcmn@comcast.net
Radio Control Aircraft/Paintball Physics/Paintball for 40+
http://home.comcast.net/~dyrgcmn/
|
|
|
|