Home Repair forum - adivce on how to replace a SUMP & MOTOR ASSEMBLY on a kenmore dishwasher

You are viewing an archived Text-only version of the thread. To view this thread in it's original format and/or if you want to reply to this thread please [click here]

Author

adivce on how to replace a SUMP & MOTOR ASSEMBLY on a kenmore dishwasher

2006-01-29, 4:21 pm

I decided to replace a sump and motor assembly on a kenmore dishwasher
(model # 668.16879000).

I ordered the part through sears.com (their part # 8534884).

The black seal on the new sump assembly looks different then the
original seal.
Also the seal is molded to the assembly.

My problem is that I cannot get the new part to properly seat in the
dishwasher.
I was told by a service tech that you should libricate the seal with
dishwaser detergent prior to installation.

I did this, but no matter how hard I push the unit (from the inside of
the dishwaser) I cannot get it to snap in place.
There is only one way (I hope) to fit the part (A key on the part fits
into a slot in the bottom of the dishwasher) , so I do not think I am
putting it in wrong.
I would appreicate any advice on the proper way to install this
sump/motor.

Thanks

LinkBot