| Bennett Price 2006-01-29, 6:21 pm |
| I don't know if this applies to you but I've twice gotten the 'correct'
Sears part and it wasn't right. The part numbers were just fine - what
I received matched what I ordered but what the parts list said to order
was not right. I got vacuum cleaner belts (for the beater brush) and
door gaskets for a dishwasher that didn't fit and were clearly wrong -
though at first glance they looked OK.
t wrote:
> I decided to replace a sump and motor assembly on a kenmore dishwasher
> (model # 668.16879000).
>
> I ordered the part through sears.com (their part # 8534884).
>
> The black seal on the new sump assembly looks different then the
> original seal.
> Also the seal is molded to the assembly.
>
> My problem is that I cannot get the new part to properly seat in the
> dishwasher.
> I was told by a service tech that you should libricate the seal with
> dishwaser detergent prior to installation.
>
> I did this, but no matter how hard I push the unit (from the inside of
> the dishwaser) I cannot get it to snap in place.
> There is only one way (I hope) to fit the part (A key on the part fits
> into a slot in the bottom of the dishwasher) , so I do not think I am
> putting it in wrong.
> I would appreicate any advice on the proper way to install this
> sump/motor.
>
> Thanks
>
|