Home > Archive > Home Repair forum > April 2006 > Drywall out on kitchen... totally ripped apart-- wish list









You are viewing an archived Text-only version of the thread. To view this thread in it's original format and/or if you want to reply to this thread please [click here]

 

Author Drywall out on kitchen... totally ripped apart-- wish list
Jack

2006-04-27, 9:21 pm

Have my entire kitchen/dining room drywall ripped out... back to the
studs.


What should I be doing now that I am not thinking of.. or better
stated.. what have those of you who have finished kitchens said.. I
wish I would have thought of this.. or done this when I had the place
wide open.

Doug Miller

2006-04-27, 9:21 pm

In article <1146180307.537670.83300@g10g2000cwb.googlegroups.com>, "Jack" <jackjohansson@gmail.com> wrote:
>Have my entire kitchen/dining room drywall ripped out... back to the
>studs.
>
>
>What should I be doing now that I am not thinking of.. or better
>stated.. what have those of you who have finished kitchens said.. I
>wish I would have thought of this.. or done this when I had the place
>wide open.
>

Insulate.

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.
PipeDown

2006-04-27, 9:21 pm


"Jack" <jackjohansson@gmail.com> wrote in message
news:1146180307.537670.83300@g10g2000cwb.googlegroups.com...
> Have my entire kitchen/dining room drywall ripped out... back to the
> studs.
>
>
> What should I be doing now that I am not thinking of.. or better
> stated.. what have those of you who have finished kitchens said.. I
> wish I would have thought of this.. or done this when I had the place
> wide open.
>


Whats on the other side of the wall, good time to update those receptacles
or plumbing as well. Be careful not to open a fire wall between the kitchen
and garage.

Main thing is to have enough branch circuits and receptacles (in the right
spots) to satisfy code+. Dedicated valves for the dishwasher and ice maker
would be nice too. Don't forget the phone, cable, intercom and internet
wires.

Wiring or transformers for undercabmet lighting should be considered as well
as the locations for the switches (3 way, one for each entry)

Also be sure to install any additional blocking to support the range hood or
wall mounted microwave oven now.



Murray Peterson

2006-04-28, 1:21 am

"Jack" <jackjohansson@gmail.com> wrote in news:1146180307.537670.83300
@g10g2000cwb.googlegroups.com:

> What should I be doing now that I am not thinking of.. or better
> stated.. what have those of you who have finished kitchens said.. I
> wish I would have thought of this.. or done this when I had the place
> wide open.


After you have done evrything suggested by PipeDown, get someone in to
spray rhe walls with foam insulation. Airtight, with no vapour barrier
needed.
The Reverend Natural Light

2006-04-28, 11:21 am

How about RG6 and power into a cabinet for one of those under-cabinet
LCD TVs.

And a hood fan with a duct that actually exhausts outside.


-rev

dave

2006-04-28, 1:21 pm

Eat in kitchen? run appropriate speaker wire to the upper corners.
Someday, she will want classical surround sound as she reads the
morning paper. Trust me on this.

BocesLib@gmail.com

2006-04-28, 2:21 pm

Humm interesting nobody mentioned this...

But while all the studs are exposed I would sure as
hell make sure that the walls are nice and flat.
Any irregularities can show themselves when installing
the cabinets.

I would also consider a new installation windows while I am
at it. Depending on location think about an exhaust fan and
its wiring.

I would wire it all to code... You'll end up having a few new circuits
going to the panel. Consider different lighting in there.
Insulation (as others stated) wouldnt be a bad idea at all.
Consider a new 3 way wire to the ceiling fan (if you have one)

What's on the other side of the kitchen walls??? Want any
outlets or anything else on those walls?????

I would change out ANY old valves with new ones. If you
use natural gas for the stove, consider changing that valve too.

Only other thing I would suggest is taking pics with the digital camera
along the way. Its good to have before, in the middle and after pics.

Tom

tim1198

2006-04-30, 8:21 am

I just did mine, and things mentioned below are definitely worth it:
Speaker wires to nearby TV, so you can cook and hear the TV at the same
time, undercabinet lighting wires, cable, balancing your outlets to
match the amperage rating, insulate.

AND the most important of all, put in drain plugs for easy access to
drains when they clog. I have mine directly inside a cabinet that
allows direct access to the main pipe without having to go through many
bends. What a lifesaver..

good luck, tim1198

LinkBot





Other archives available: Cellular phones topics archive | Web Design forum archive | Software help archive | Hardware reviews archive | Programming topics archive

Copyright 2004 - 2009 homeownerschat.com