Construction forum - Gutter question

You are viewing an archived Text-only version of the thread. To view this thread in it's original format and/or if you want to reply to this thread please [click here]

Author

Gutter question

Gus

2006-04-20, 11:21 am

I am going to put gutters on my house and have been taking estimates.

I ran into a big difference with one company as to how they install
corners differently than the others.

Most use a pre-made corners and connect the seamless gutters to them.

I found one company that uses a narrow molded strip on the tip of the
corner then cuts the seamless gutters at 45 degrees and uses a couple
small screws on the inside of the back of the gutter, then caucks the
whole thing.
This gives a very sharp edge with no fitting joints near the corner.
They look good but is this the best of the two methods to use?

Thanks,
Gus

LinkBot