|
Home > Archive > Electronics repair > April 2005 > Replacing those 'can' type electros
You are viewing an archived Text-only version of the thread.
To view this thread in it's original format and/or if you want to reply to
this thread please [click here]
| Author |
Replacing those 'can' type electros
|
|
| tempus fugit 2005-04-16, 3:16 pm |
| Hey all;
I've got an old tube amp with a lot of hum so I am going to replace the
filter caps. The problem is, they are in a can. The can says
10uF 350 (with a little trangle beside it)
10uF 350 (with a little square beside it)
2uF 350
I think I can figure that part out. The can has 3 terminals and is grounded
to the chassis. Can I assume from this that each of the terminals is the +
of the cap and the - is connected to ground? Also, how do I figure out which
terminal goes to which cap? What do the triangle and square mean?
Thanks
| |
| Sam Goldwasser 2005-04-16, 3:16 pm |
| "tempus fugit" <toccata@no.spam.ciaccess.com> writes:
quote:
> Hey all;
>
> I've got an old tube amp with a lot of hum so I am going to replace the
> filter caps. The problem is, they are in a can. The can says
> 10uF 350 (with a little trangle beside it)
> 10uF 350 (with a little square beside it)
> 2uF 350
>
> I think I can figure that part out. The can has 3 terminals and is grounded
> to the chassis. Can I assume from this that each of the terminals is the +
> of the cap and the - is connected to ground? Also, how do I figure out which
> terminal goes to which cap? What do the triangle and square mean?
On the bottom, you'll see corresponding triangles, squares, etc., to identify
the positive terminals. The negatives are the can unless otherwise indicated.
--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html
Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.
Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.
| |
| Mr. Land 2005-04-16, 3:16 pm |
| There are 3 separate electrolytics in that can. As you guessed, all of
their negatives are tied together. If you look at the terminals you
should see the corresponding triangle and square, identifying the
postive terminals for the 10uF portions.
Good luck with the hum...
| |
| tempus fugit 2005-04-16, 3:16 pm |
| Thanks a lot guys. That explains the shapes...
"Mr. Land" <graftonfot@yahoo.com> wrote in message
news:1113191195.797284.149110@z14g2000cwz.googlegroups.com...
quote:
> There are 3 separate electrolytics in that can. As you guessed, all of
> their negatives are tied together. If you look at the terminals you
> should see the corresponding triangle and square, identifying the
> postive terminals for the 10uF portions.
>
> Good luck with the hum...
>
|
|
|
|
|